The following operating and maintenance instructions springs are very important and must be parts followed carefully.
During this learning process, the device(s) connected to OUT8 (direct output, no relay) must be springs disconnected (or off).
Lower water temperatures are recommended for extended use (exceeding 10 minutes) and for young children.
4 AWG minimum 75C copper conductor between springs this unit and any metal equipment, metal enclosures of electrical equipment, metal water pipe, or conduct within 5 feet (1.52 m) of the unit.Nor is any liability assumed for damages resulting from use of the information contained herein.Also used for ltration.This form collects data so that springs HotSpring and/or one of our authorized HotSpring retailers can communicate with you and provide assistance.Case 3 Please note that in a 3-phase system 1 x 230 VAC (3 x 16A) No jumper installation is required.Empty out some water and add fresh.Here again, with proper planning, no matter what room your spa goes in, it manual will be your favorite parts room.Clean with a garden hose equipped with a high pressure nozzle, or soak in lter cartridge cleaner if necessary, or at every other regularly scheduled cleaning.3 Concrete pad note!Neither Dynasty Spas nor its subsidiaries accept any responsibility for any representations, statements or contracts made by any Spa parts Dealer/Contractor.Clean cover both inside and out with diluted bleach.A B, c D, e F, g H, i J, k L, m., s T, u V,.
The water in the crack spa should never exceed 104 F adhesive (40 C).
Should the need arise to replace the suction ttings or the pump, be sure that the ow rates are compatible.
A spa may be installed within ve (5) feet (1.52 m) of metal surfaces if, in accordance with the National Electrical Code / IEC, each metal surface is permanently connected by a minimum.The replaceable adhesive lter cartridge is trouble free and easy to clean.Sec1:20 Spa partition Operators Guide (XM.We have this trouble to a lesser extent in our other bodies of water at the resort.(refer to page 22) Caution: Connect only to a circuit protected by a class A ground fault circuit interrupter.Your spa dealer will advise you on how to protect your investment.Always enter and exit a spa slowly.After resetting, the system starts a learning sequence in which each individual output is activated patch and its peak current displayed and saved.Note: If unusual current readings.g.: 4 to 6 amps are detected on the high speed of any pump, all pumps must be primed and the learning mode should be restarted.This manual should help to eliminate pillows becoming stiff and discolored.It is very important that you, as a spa owner, review the important safety instructions and warnings before parts you operate your spa.Decking must be constructed to support 85 pounds per.Neutral Bar White Pig tail White Fro m Spa White Fro m Spa White Pig tail White Pigtail white wire TO THE SPA Ne utral Bar Ne utral Bar White Pigtail Neutral Bar For spa wiring TO SPA conguration please refer to page.Xm pack Reset the spa pack by shutting the breaker off then on again, manually change the status of all the pumps and accessories.Temperature inside the spa skirt is too high, causing the internal temperature in the.
Assumes no responsibility for errors or omissions.
The limited warranty does not cover damage hot springs hot tub parts manual resulting from improper maintenance, improper installation, misuse, abuse, accident, re, normal acts of God, wear and tear, or improper water maintenance.